基于
Matlab
?/p>
AM
振幅调制与解调仿?/p>
摘要?/p>
本次高频电子电路大作业的设计,我组所选的题目为振幅调制电路(
AM
?/p>
?/p>
解调?/p>
在本课程设计报告中,
首先说明了进行此次课程设计的目的?/p>
内容及要求;
阐明了标准振幅调制与解调的基本原理以及操作方法,
同时也对滤波电路的原?/p>
加以说明。接着叙述了利?/p>
Matlab
软件对振幅调制、解调以及滤波器等所设计
编写的程序,并附上了调试后输出的载波信号、调制信号?/p>
AM
已调信号及滤?/p>
前后的解调信号等的波形图和频谱图?/p>
另外还附上了滤波器的增益响应和双边带
总功率与平均总功率之比。报告的最后,是个人对本次大作业结果的分析?/p>
过程
反思以及总结?/p>
关键词:振幅调制
解调
AM Matlab
仿真
Abstract
?/p>
In The high-frequency electronic circuit designing job, our group selected the
topic as amplitude modulation circuit (AM) and demodulation. In this course design
report, first explains the purpose, content and requirements of the curriculum design;
clarify the basic principles and methods of operation standard amplitude modulation
and demodulation, and also to illustrate the principles of the filter circuit. Then
describes the use of Matlab and other amplitude modulation, demodulation and filter
design program written, along with the carrier signal debugging output modulation
signal, AM modulated and demodulated signal waveform signal before and after
filtering, etc. map and spectrum, also attached a total power and average power ratio
of the total gain response and bilateral band filter. At the end of the report is to
analyze the individual results of this large operation, process reflection and summary.
Keywords: amplitude modulation, demodulation, Matlab simulation